3 Tests Quality Kingston GA Septic System Installers Perform Before Designing

Quality Kingston GA septic system installers do a great deal of examination, long before a unit gets put into the ground. A new unit will last decades, and possibly even generations, if it’s set up properly, but it can malfunction instantly if it’s not. Furthermore, all Kingston GA septic system installers must obtain a permit for them to do the install, and may ought to collaborate with city or county officials to show that specific tests were run in order to proceed. These three tests are essential primary steps that should always be taken before any job or designs are done, and it may also be beneficial to perform them before you buy a property, so you can be assured that a tank and leach field will be permitted.

1. Pit

The pit test is very straightforward. During this test, a hole is dug down and the soil is analyzed to establish its composition. A conventional leach field is dependent on the soil’s structure to drain effectively. If there is a considerable amount of gravel or sand, your leach field should be ready to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a lot of clay or rock, it won’t drain well, therefore a standard leach field will not be an alternative. If the location you’ve picked does not pass the pit test, you may be able to select another site on your house or use an alternate type of drain field, such as a mound system.

2. Perc

The perc, or percolation test, requires excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is normally left saturated for about two hours, and topped off as needed. Then, the hole is filled with 6 inches of water and monitored for drainage.

3. Visual

There are several things an inspector will check visually. Most units are gravity-fed, so they don’t depend on electricity or pumps to transfer effluent from the tank to the leach field. As a result of this, the incline of the ground is essential. An inspector will also search for inclines that can feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.

Work with Quality Kingston GA Septic System Installers Today

Selecting the right design, type of system, and assessing the land correctly, are all integral procedures in making sure an install goes off without a hitch. Most significantly, these steps guarantee that the install is done properly, so that a system provides decades of use without issue. If you’re preparing for an install, call Septic Tank Pros Rome GA. Our partner service technicians are skilled and devoted to quality, so you could be sure the job is done right. Call (706) 204-3004 right now.

The post 3 Tests Quality Kingston GA Septic System Installers Perform Before Designing appeared first on Septic Tank Pros Rome GA.

from Septic Tank Pros Rome GA http://septictankromega.com/kingston-ga-septic-system-installers/
via IFTTT